One, the program stop how to skip the processed part?
1, remember the sequence number of the program stop (line number, in case of power failure program) etc. can not remember the line number, after reboot to view
Processing parameter setting off serial number value in picture).
In 2, the executive process of the page, move the cursor to the serial number column.
3, enter the serial number of the program stop.
4, to confirm the sequence number of the correct input, press the Enter key, there will be the point of interruption to find, once again confirmed.
Before 5, executing the program, select the handwheel simulation method.
6, executing the program start, the hand wheel is rotated to confirm the interruption point is correct.
7, determine the safety after processing, executing the program automatic processing.
Two, processing or a sudden power outage trip, cause the machine boot newspaper, "processing data lost alarm" how to remove?
1, the alarm to remind the user to confirm the processing data, better protection of customer products processing, to avoid accidental loss of data processing of waste situation appears.
2, customers only need to restart again machine, the alarm is automatically cancelled.
Three, aligning instrument automatic knife. The elimination method used and trouble?
The length of the tool cannot be used on the main shaft 1, exceeds the maximum length (length based on model decision).
2, automatic tool setting enabled should not be to move the tool path interference and the barrier, height of workpiece can not affect the Z axis of the sheet metal lifting
3, the workpiece fixed to the attention of fixture can not meet tool setting gauge fixing bracket.
4, aligning instrument tool surface should pay attention to whether or not clean.
Four, drive alarm how to do?
1, check the display which is the axis to sound the alarm.
2, open the box door, find the corresponding driver.
The machining center machine and drilling and tapping machine, drive in the power distribution board at the upper left, XYZ axis corresponds to the order: first from left to right, from top to bottom after.
The engraving and milling machine, drive below the power distribution board left, XYZ axis corresponds to the order: from left to right.
3, check the drive screen display alarm code, display form 8 code form the general alarm AC9, A10, A84 etc..
4, please put down the drive alarm code copy, contact me ticket service personnel, we will as soon as possible to solve the problem for you.
|
